Russell and Bromley Knee High Boots Resale Value

Russell and Bromley knee high boots: price by condition

Seller-declared grades, sterling with an approximate US dollar equivalent at £1 ≈ $1.33 (July 2026). What each grade means.

What holds its value across Russell and Bromley

• Leather-soled and welted construction, which can be resoled repeatedly and is the reason these shoes outlast their first owner
• Made-in-Italy and made-in-Spain stamps, which are inside the shoe and are what buyers look for first
• Classic loafers and Chelsea boots in black and tan, which sit outside seasonal trends entirely
• Boxed pairs with the shoe bags, which the brand supplied and which signal careful ownership

What pulls Russell and Bromley resale value down

• Soles worn through at the ball of the foot, which crosses from resoleable into a repair the buyer must pay for
• Deep creasing across the vamp on fine leather, which is permanent and is where these shoes show their mileage
• Dried and cracked leather from storage without shoe trees, which cannot be brought back fully
• Suede with water staining, which is very apparent in daylight and is not something a home clean fixes

Identifying and dating yours

1. Photograph the inside of the shoe showing the country of manufacture and the size stamp together
2. Show the sole from underneath, so the buyer can judge remaining life and whether a resole is due
3. Say whether the shoe is welted or glued, because that decides whether it can be resoled at all

What lifts any knee high boots, whatever the label

Knee-high boots are judged on shaft condition and calf fit, and the calf measurement is what listings most often omit.

• Supple leather with no cracking at the ankle
• Shafts that stand rather than slouch, if the style intends it
• Working full-length zips
• Recognised makers with a following

And what pulls one down

• Cracking at the ankle flex point
• Broken or split full-length zips
• Slouched or misshapen shafts
• Very narrow calf fittings

Working out what yours is worth

1. Measure the calf circumference and shaft height
2. Work the full-length zip several times
3. Flex the ankle and check for cracking

What to state in the listing

• Size as marked, with UK, EU and US equivalents
• Calf circumference and shaft height in centimetres, measured flat
• Heel height and type
• Material, zip condition, and whether the shaft is stretch-panelled

Brand, material, size and shaft: “Leather Knee High Boots, Size 6, Black, 38cm Calf”. Putting the calf measurement in the title is unusual and it works, because a large share of buyers have been caught out by a shaft that would not close and now search specifically for one that will.

Preparing and photographing it

1. Measure the calf circumference at the widest point of the shaft, with the boot zipped and lying flat.
2. Test the zips fully up and down. A sticking zip is the most common fault and, on a tall shaft, it makes the boot unwearable.
3. Stuff the shafts so they stand upright, and clean the leather or brush the suede before photographing.

1. The pair standing upright, full height, side on
2. A tape measure across the calf at the widest point of the shaft
3. Both soles and heel tips
4. The zip full length, the inside label, and any crease, scuff or scratch

When it sells best, and handing it over

Autumn and early winter carry this category almost entirely. Listed in September or October a good pair sells quickly; the same boots in April will barely be seen.

Bulkier than most footwear, so use a proper box and quote postage from an actual weight. Do not fold the shafts to make them fit a smaller box — leather creases permanently.

What buyers ask

Are these shoes worth resoling before selling?

If they are welted, a resole can pay for itself on a classic style. If they are glued construction, sell them as they are and price honestly.

Why do they hold value better than other high-street shoes?

Because the construction is genuinely better and the leather is real, so a used pair has years left rather than months. Buyers who know the brand know that.

How much are Russell and Bromley knee high boots worth?

Roughly £29 to £126 depending on condition, against £25 to £110 for knee high boots generally. The identification points above are what move a listing to the top of that range.

What the fees would take elsewhere

At the mid-range £77 for Russell and Bromley knee high boots, against what the commission marketplaces would deduct:

Seller-side rates verified 26 Jul 2026, percentages only — the per-order and processing charges those platforms add are excluded, so the real gap is wider.

Listing is free and there is no commission — read how to sell knee high boots for the title, handover and timing, or the general knee high boots value guide if yours is not a Russell and Bromley.

See also: all Russell and Bromley value guides · value guides by brand · buying knee high boots · Shoes & Footwear · condition grades.